Warning:
Aquabarrel.com requires the use of Javascript to view the website, please use a modern web browser with Javascript enabled for viewing.

Typical RainBox Rainwater Storage System Installation

	You will need a level, shovel, sand, pea gravel, hacksaw, screwdriver, drill with 1.75inch hole saw bit.
	Remove the top layer of soil to a depth of at least 1 inch or more. Fill with at least one quarter inch of sand. The next layer is pea gravel. Place flat stone (ie: patio block) on gravel and level this surface.
	Place the Aquabarrel RainBox on the flat, level surface. Drill out overflow port on the correct side of the RainBox. Install an elbow and point it towards the ground.
	Measure up from the top of the RainBox and mark the location to cut the downspout. Cut downspout and install downspout elbows, downspout diverter or flexible hose. Dig a trench wide and deep enough to accomodate your 2 inch PVC overflow pipe.
	After laying pipe make sure the pipe runs downhill away from the home and RainBox.
	Backfill the hole and replace the sod.

No returns

We are unable to accept a RainBox for return. This product may not be shipped inside of a wasteful cardboard container. It may attain a few bumps, bruises or scrapes during transit. None of these cosmetic imperfections will effect the barrels ability to hold liquid.

* 48 States Only - Other areas please email for pricing before placing your order.

Made in the USA